Squeegee for vinyl
5,00€
Vinyl Squeegee - Rims and fairings
Did you put your deco kit or your stickers rims in your Cart ? Don't forget to add a vinyl scraper to easily apply your stickers ! Made of high quality plastic, this squeegee will allow you to apply the stickers rims and remove the wrinkles.
Size of the scraper : 10cm x 7.3cm
Description
Vinyl Squeegee - Rims and fairings
Did you put your deco kit or your stickers rims in your Cart ? Don't forget to add a vinyl scraper to easily apply your stickers ! Made of high quality plastic, this squeegee will allow you to apply the stickers rims and remove the wrinkles.
Size of the scraper : 10cm x 7.3cm
 How to install your stickers ?
Installing your stickers is easy but essential for a long lasting effect.
You can follow our video tutorial or article to know the steps.
Here are a few tips beforehand:
- Place the stickers in a wind and dust free environment and at moderate temperatures (between 15 and 25°)
- Do not use WD40 or other products with silicone to clean the rims,
- The rims must be perfectly clean,
- If the stickers are not installed immediately, store them in a dry place out of the sun,
- You can use our self-adhesive scraper for a clean finish and to optimize your stickers,
- Prefer a resting time after application of 24-48H.
How to use the vinyl scraper?
For an optimal hold of your stickers, you can use the scraper several times.
- Scrape your stickers on a flat surface to make sure it sticks to the transfer,
- Once the stickers are placed on the surface where to stick them, scrape again so that they take well,
- When you have peeled off the transfer, scrape off any bubbles or wrinkles by heating your stickers .
- In case of stubborn bubbles, you can pierce them with a fine sewing needle.
Scraping and heating your stickers as well as the surface is the best hack for a beautiful pose and improve the longevity.
Moreover, no risk of breaking your credit card or loyalty card while scraping!
Notice
There are no reviews yet.